This is a Fred's House model that was printed too big in error. At an estimated 1/80 scale it's too big for HO but would suit OO scale if you're not too worried about a few fractions of a scale. Put it towards the back of the layout for some forced perspective maybe. I print all the buildings on the back half of my layout 10% smaller for that reason. Anyhoo, it's painted and glazed and I don't want it anymore.
Left over from a print run of 1/64 scale Oil Drums. Packet of 10 individual drum. Oil drums are available in any scale, but this is special to clear some spare stock.
These are left over RailEx stock which are unpainted and still in their supports. The painted versions in the photo are just to show what they look like finished.
These are replacement FEP release films for Elegoo Mars 4. Three of them in original packaging. Usually over $20 each.
This vintage water tower was inspired by the one at Paekakariki and adds a bit of history and charm to any layout.
Supplied as a one-piece unpainted 3D resin print.
Note: delicate model, please handle with care.
These came off the printer with deformed rear wheels. HO only. Supplied as one piece unpainted resin print. Limited stock.
I accidentally left this N scale print soaking in the rinse water overnight and it has left it less than perfect. The biggest problem is the split at the rear on the corner of the second story. It also is just a bit rough. But weathered up it will still look great as it is a derelict. A good opportunity to score a cheap derelict. It has had a prime spray coat applied but is otherwise unpainted.
This is an early print version - unpainted. The main problem with this version is the bowing of the walls before I reinforced the design. It will still look great as a derelict on your layout. A good opportunity to grab a cheap little feature for your layout.
As I upgrade the structures on my layout I make available the old FDM printed models. This is the Old Workshop from the Fern Valley Layout.